You are currently shopping on our GPS City USA website, which ships to the USA and Internationally. To shop on our Canada website, which ships to Canada only, please click the green button above. Prices will be in CAD$.
Please note: You may lose the contents of your shopping cart when you change websites.
RAM Mount Radio Belt Clip Bar Yoke Mount Specifications
Please find below additional technical documentation and/or specifications for this item. This documentation may take the form of mechanical drawings, installation manuals, instruction manuals, and a table of specifications.
RAM-B-121-BC1U
The RAM Marine Grade Aluminum Yoke Mount consists of the 1'' dia. ball and socket system with RAM Plastic Universal Belt Clip Cradle.
BASE DESIGN:
The RAM-B-121B RAM Mount Powder Coated Marine Grade Aluminum Yoke Clamp Mount Base fits a rail diameter from 5/8 inch to a maximum of 1 1/4 inches. The 1 inch rubber ball is at a right angle to the plane of the mount so when connected to a rail, the ball sits parallel to the rail. To mount the base, simply place the yoke clamps around the rail and then screw the large knob at the end of the threaded rod. The hand tightened clamp makes this the perfect mounting system for rental planes and unusual shaped motorbike rails.
NOTE: The rail does not need to be perfectly round to mount this base.
ARM DESIGN: The Powder Coated Marine Grade Aluminum Standard Length Double Socket Arm is 3.0'' long when measured between socket centers.
CRADLE DESIGN:
The RAM-HOL-BC1 Universal Belt Clip Bar Holder is a High Strength Plastic Composite Cradle designed to hold many different electronic devices with a connected belt clip. The most common use for this mount is handheld radios. To place a unit onto the holder, simply slide the belt clip on you device over the 1 1/8'' long x 1/16'' wide plastic support bar. The belt clip can be part of the unit or part of a protective case.
The RAM-B-121B RAM Mount Powder Coated Marine Grade Aluminum Yoke Clamp Mount Base fits a rail diameter from 5/8 inch to a maximum of 1 1/4 inches. The 1 inch rubber ball is at a right angle to the plane of the mount so when connected to a rail, the ball sits parallel to the rail. To mount the base, simply place the yoke clamps around the rail and then screw the large knob at the end of the threaded rod. The hand tightened clamp makes this the perfect mounting system for rental planes and unusual shaped motorbike rails.
