1. Begin your review here
4. Submit your review
Please enter the characters you see below into the box beside it, then click 'Submit Review'. This helps prevent automated spammers.
Garmin 2 Pack Large Adhesive Plate for Suction Cups
Tips For Writing A Good Review
Rate the item from 1 to 5, where: 1 = very poor 2 = poor 3 = average 4 = good 5 = very good
Explain in simple terms why you like or dislike the product based on the product's functionality and your experience using the product
Avoid single-word reviews, bad language, contact information (email addresses, phone numbers, etc.), or URLs
All submissions are governed by our Terms of Use
Got questions? We've got answers!
Occasionally we receive reviews from users who are experiencing problems with items. If this is the case with your review, please continue with your candid review, but remember that we also offer our free Q&A service to help resolve your problem. Just pop on over to the Q&A page to ask a question and we will respond with an answer to get you back up and running!
Recent reviews for this item:
Donald, November 16, 2009
The plates themselves are great but the sticky pad was pass
due and there was no way to permanently glued it to the
dash board.
I had to buy 3M sticky pads at the hardware store to make
the job properly.
Carol, October 28, 2009
The plate does not stick to my dash. I bought a 2005 Lexus
330 and I cannot get the suction plate to stick to the
dash. Any suggestions? I followed the directions property.
I had an older Lexus and it worked fine.
Escape Owner, May 12, 2009
This item consists of two adhesive discs and two
plates. (I only needed the adhesive disc.) The
adhesive discs are cut from thin plastic sheet
with adhesive both sides. The original Garmin
disc was made from a relatively thick foam, and so
could compensate for a dash that was not perfectly
flat.
Also, the adhesive did not stick to my dash, but
that could have been due to some polish applied by
a previous owner
A_Man, August 18, 2008
The mount, which is similar to the one that is supplied by Garmin,
comes with no instructions, and is also different in that the double
sided adhesive patch comes separately (the Garmin original is already
attached to the plate). And therein lies the problem....The patch
sticks fine to the dash board, and also stuck fine to the plate...but
only for a day. The adhesion to the plate does not seem to work. It
appears that maybe due to the design of the plate, or bad adhesive,
it does not stay stuck to the plate (and I can't get if off the
dash) - I have tried sticking it back, and have had the GPS fall off
every time while driving. I would not reccomend this product