| 4. Submit your review |
| Please enter the characters you see below into the box beside it, then click 'Submit Review'. This helps prevent automated spammers. |
|
|
|
The RAM Mount 0.25 inch NPT Thread with Single 1 inch Ball
| Tips For Writing A Good Review |
| • |
Rate the item from 1 to 5, where:
1 = very poor
2 = poor
3 = average
4 = good
5 = very good |
| • |
Explain in simple terms why you like or dislike the product based on the product's functionality and your experience using the product |
| • |
Avoid single-word reviews, bad language, contact information (email addresses, phone numbers, etc.), or URLs |
| • |
All submissions are governed by our Terms of Use |
|
|
|
Got questions?
We've got answers! |
Occasionally we receive reviews from users who are experiencing problems with items.
If this is the case with your review, please continue with your candid review, but remember that we also offer our free Q&A service to help resolve your problem.
Just pop on over to the Q&A page to ask a question and we will respond with an answer to get you back up and running!
|
| Recent reviews for this item: |  |
| Dave, February 8, 2012 |
| This was the nicest part I received in the mounting system I
purchased. | |
| Kent Magnuson, April 1, 2011 |
| I used this ball end, attached to a Flex Arm, mounting an iPad
to our airplane floor. This was a very good end, but not the
one I ended up using. The iPad cradle I had, already had a
ball mount attached, so I opted for a socket on the Flex Arm
instead. This works as well, if you have a female-end on the
cradle. I needed less flex on the floor end, so opted for a
plate to screw the bottom end of Flex Arm into. | |
| Wayne, February 13, 2011 |
| Not much to this part, but it's still well made | |
